產品概述 Product description
IVD電容器設計用于低壓網絡中的功率因數校正（PFC）。它們可用于：
-電機，變壓器等的單獨固定PFC
-自動PFC設備
-調諧和失諧的電容器組
IVD-C電容器具有三個獨立的金屬化聚丙烯膜繞組，分別位于圓柱鋁罐中。內部以星形或三角形連接。使用三個獨立的堆疊繞組可確保低損耗，具備優異的浪涌電流性能以及繞組的良好散熱。繞組的高真空干燥可以在恒定電容的情況下延長使用壽命。
由于開關操作，在低壓電網中可能會出現不超過額定電壓3倍的電壓峰值。如果這些應力引起電介質擊穿，則自愈機制將發揮作用。自愈后，電容器繼續正常工作。電容容量衰減可以忽略不計。
IVD電容器配有拉斷保護。當故障點反復自我修復或任何其他內部故障導致的內部壓力上升達到額定值時，拉斷保護動作。在這種情況下，鋁蓋可能會鼓出，并且電容器會在軸向上膨脹。膨脹導致內部連接線斷開，電容器從電力系統安全地?cái)嚅_(kāi)。
電容器內置放電電阻，保證電容器電壓在3分鐘內放電至36V或以下。
Application
IVD capacitors are designed for power factor correction (PFC) in low voltage networks. They may be used for:
- Individual fixed PFC of motors, transformers, etc.
- Automatic PFC equipment
- Tuned and detuned capacitor banks
Construction
The IVD capacitors have three separate windings from metalized polypropylene film placed in a cylindrical aluminium can. The partial capacitances may be connected either in star or delta configuration. The use of three separate stacked windings guarantees low losses, optimal surge current performance and good heat drain from the windings. A high-vacuum drying of the windings gives long service life with constant capacitance.
The terminal is designed as a double 3-pole terminal block (IP 20).It is possible to clamp multiple-wires with a cross section up to 35 mm2 ．
Due to switching operations, inadmissible voltage peaks of up to 3 times that of the rated voltage can occur in low voltage networks. If these stresses affect a dielectric breakdown, the self-healing mechanism will function. After self-healing, the capacitor continues its complete operation. The decrease in capacitance is negligible.
IVD capacitors are equipped with an overpressure expansion fuse. The fuse operates when the internal pressure rise affected by repeated self-healings on faulty spots or any other internal failure has reached a determined value. In this case the lid of the aluminium can bulge out and the capacitor expands in the axial direction. Due to this expansion the planned fracture in the internal connecting wires break and the power capacitor is disconnected safely from power supply system.
Power capacitors must be discharged in 3 minutes to 36V or less. No switch, fuse or any other isolating device should be between the power capacitor and the discharge device. Power capacitors which are directly connected to other electrical equipment providing a discharge path can be considered as properly discharged, provided that the circuit characteristics ensure the discharge of the power capacitor within the time specified above. IVD capacitors will be delivered with discharge resistors.
面圖片1.jpg)
技術參數Technical parameter
Rated voltage 230～690V Rated frequency 50/60Hz Capacitance tolerance -5%+10% | Climatic category -25/D Max. ambient temp.: 55℃ Max. ambient temp. over 24h: 45℃ | 額定電壓； 230～690V 額定頻率 50/60Hz 電容公差 -5%+10% | 氣候環境： -25/D 最高環境溫度： 55℃ 最高環境溫度超過，24h: 45℃ | |
Over voltages Un+10% up to 8h daily Un+15% up to 30 min.daily Un+20% up to 5 minutes Un + 30% up to 1 minute
| Max.ambient temp.over 1year: 35°C Lowest temperature: -45℃ Max. case temperature: 65℃ Humidity Average relative<95% | 過電壓 Un+10% 每天高達8小時 Un+15% 每天30分鐘 Un+20% 最多5分鐘 Un + 30%最多1分鐘
| 最高環境溫度超過，1年: 35℃ 最低溫度： -45℃ 殼體最高溫度 65℃ 濕度≤95% | |
Over current 1,5×In (including harmonics) Inrush current Max.200xIn Test voltage terminal/Terminal 2,15×Un AC (2s) Test voltage terminal/case 3,6 kV AC (10s) | Altitude 2000m Cooling Natural or forced Mounting position Vertical / horizontal Installation Indoor | 過電流 1,5×In (含諧波) 勵磁涌流 Max.200xIn 測試電壓端子/端子 2,15×Un AC (2s) 測試電壓端子/外殼 3,6 kV AC (10s) | 海拔 4000m 冷卻 自然或強壓 安裝位置： 垂直/水平安裝 安裝： 室內安裝 | |
Dielectric Polypropylene film, Self-healing Impregnation (filling) Inert insulation gas Losses Dielectric: 0.2W/kvar Total capacitor (50 Hz): < 0.4W/kvar Life expectancy > 150,000 h 5000 switchings per year Standards IEC 60831-1/2 GB/12747-1/2 UL 810 | Case Cylindrical, aluminium Fixing Threaded bolt M12 Max torque(Al can stud):10Nm Terminals Degree of protection: IP20 Terminals cross section: 25mm2, 35mm2 Max. torque: 3 Nm Discharge resistor time: <3 minutes to 36V Safety device Overpressure disconnector | 電介質 聚丙烯薄膜，自愈 填充物 惰性絕緣氣體 損失 電介質：0.2W/kvar 總電容器（50Hz）： <0.4W/kvar
預期壽命 >150,000 h 每年5000次開關 標準 IEC 60381-1/2 GB/12747-1/2 UL 810 | 材質： 圓柱形鋁 固定： 螺紋螺栓M12、最大扭矩12nm 防護等級： IP20 端子截面： 16mm2, 25mm2, 35mm2 放電電阻時間： ＜3分鐘至36V 安全裝置 過壓隔離開關
|
拉斷保護Pull off protection specifications
常用規格表Common specifications
1）三相 50Hz 電壓480V
Order code 訂購代碼 | Rated power 額定功率 | Rated capacitance 額定容值 | Rated current 額定電流 | Weight 重量 | Dimension 尺寸 |
kvar | μF+10/-5% | A | kg | D×H(mm) | |
IVD-C/480/25 | 25 | 3×115.1 | 30.1 | 2 | 116×235 |
IVD-C/480/30 | 30 | 3×138.2 | 36.1 | 2.5 | 116×280 |
2）三相 50Hz 電壓525V
Order code 訂購代碼 | Rated power 額定功率 | Rated capacitance 額定容值 | Rated current 額定電流 | Weight 重量 | Dimension 尺寸 |
kvar | μF+10/-5% | A | kg | D×H(mm) | |
IVD-C/525/25 | 25 | 3×96.2 | 27.5 | 2 | 116×235 |
IVD-C/525/30 | 30 | 3×115.1 | 33 | 2 | 116×280 |
3）1P 50Hz 電壓280V
Order code 訂購代碼 | Rated power 額定功率 | Rated capacitance 額定容值 | Rated current 額定電流 | Weight 重量 | Dimension 尺寸 |
kvar | μF+10/-5% | A | kg | D×H(mm) | |
IVD-C/280/10-1 | 10 | 1×406 | 35.7 | 1.1 | 85×231 |
IVD-C/280/15-1 | 15 | 1×609 | 56.3 | 1.9 | 116×250 |
4）1P 50Hz 電壓300V
Order code 訂購代碼 | Rated power 額定功率 | Rated capacitance 額定容值 | Rated current 額定電流 | Weight 重量 | Dimension 尺寸 |
kvar | μF+10/-5% | A | kg | D×H(mm) | |
IVD-C/300/10-1 | 10 | 1×354 | 33.3 | 1.1 | 85×231 |
IVD-C/300/15-1 | 15 | 1×531 | 49.9 | 1.9 | 116×250 |
★以上僅列出常用型號，其他規格請洽本公司。
